Pioneer sled runners-installation

DAPNET Forums Archive › Forums › Equipment Category › Equipment › Pioneer sled runners-installation

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 27, 2010 at 11:53 pm #41483
    Lady in VA
    Participant

    Please forgive my ignorance… I purchased sled runners for my Pioneer forecart (has hydra. brakes). There were no installation instructions. Scanning the ‘net, I’ve seen some sites say “Remove tires and install the runners”. What about the drums? Or is it that simple-just take off the tires and pop on the runners over the drums?

    I will find out from Pioneer Monday if need be. Just hoping to use the things before the snow is all gone this weekend.

    Thanks.

    February 28, 2010 at 1:36 am #58649
    Joshua Kingsley
    Participant

    The runner should bolt on to the same patern as the wheels. There should be no problem of drum interference. Same principal as putting on a spare tire when you get a flat on a wagon or on a car the runners should pop over the drums.

    Take the above advice with a grain of salt as I no longer own a pioneer cart and mine did not have brakes.
    Good luck and have fun.

    Joshua

    February 28, 2010 at 2:27 am #58648
    Jean
    Participant

    I have a pioneer cart, but no brakes. I did just take the tires off and put the runners on in their place. No worries about any drums.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.