DAPNET Forums Archive › Forums › Equipment Category › Equipment › JD No. 3
- This topic has 3 replies, 4 voices, and was last updated 10 years, 9 months ago by Jay.
- AuthorPosts
- January 21, 2014 at 12:00 pm #82179KMichelleParticipant
I found in my neighbor’s 100 acre wood lot a structurally sound, but gear rotted No. 3 mower. I haven’t actually seen the gears, but I am sure this would be a complete rebuild. Assuming I could get free, would it be worth it? Does the mechanical improvements of the 7 and 9’s, make seem impractical? On the other hand I REALLY need a mower and am on a shoestring budget.
On a romantic note, this mower was found near the foundation of a rumored ‘pioneer’ farm. Left up on huge stone blocks under a very elderly maple, with the knife still in the bar.
I would feel comfortable with a 9 or 7, but I have never restored equipment before and am not sure it’s worth it.
January 21, 2014 at 12:54 pm #82181carl nyParticipantProbably wouldn’t know until you got it out and checked it over. From what you said you could probably end up with a lot of $$ in it. That being said, I hate to see that good old stuff just rot away, could be a nice project… Look it over and see how bad it’s set-up.
carl ny
January 21, 2014 at 7:30 pm #82182LongViewFarmParticipantI am almost finished refinishing a #3. I think it’s worth giving a shot. The enclosed gears are pretty tough and protected. I say pull it out and see what you’ve got.
January 21, 2014 at 9:08 pm #82188JayParticipantI worked with Jay of LongView Farm on his #3 and found that most all of the critical parts are the same as the JD Big 4 (with the exception of the pitman crank diameter) and that can be taken care of with a shim. I suggest pulling the top off the gear box – 5 5/16 bolts that are easy to replace if they twist off. If the gears are not seized up it is probably doable. Jay
- AuthorPosts
- You must be logged in to reply to this topic.