Richard

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 17 total)
  • Author
    Posts
  • in reply to: ground drive cart #74450
    Richard
    Participant

    Finally found it

    in reply to: Number 7 wrist pin question #68685
    Richard
    Participant

    Thanks for the number. Should have parts on the way now.

    in reply to: oliver trailer plow #65796
    Richard
    Participant

    The plow behind the cart not work very well?

    in reply to: Lets See Your Plow! #55374
    Richard
    Participant

    Really good pictures. Just had a big piece of metal put in my back in October so I cant have that kind of fun. Think I will stay with the pull type tractor plow idea. Sure does look like fun though!

    in reply to: plows #57945
    Richard
    Participant

    I have seen the pictures. Certainly looks like it works good but looks can be deceiving. Thought maybe someone that has actually used one might tell us the good and the bad of this set up. Better or worse than an actual horse drawn plow. Seems to be a lot of interest in plows lately. Thought I was the only one getting spring fever.

    in reply to: two way plows #57821
    Richard
    Participant

    Wow! Did not know new ones were that expensive. Not sure I can justify that for a few acres a year. Guess I need to do some thinking about this. Thanks for the reply.

    in reply to: Mccormick #7 mower #50307
    Richard
    Participant

    Thanks for the info. Maybe I’ll get lucky soon.

    I understand your frustration. Couple of days ago I saw a #7 on St Louis craigslist. Asking $100 I think

    in reply to: Mccormick #7 mower #50306
    Richard
    Participant

    I have called Balsters, McNair, JD, Case IH and several bearing distributors no luck finding a source for bearings of this size. I was told someone advrertises in SFJ that makes something for replacement in these mowers. Not sure who I’m looking for. Need more numbers of places to call. Thanks

    in reply to: Mccormick #7 mower #50305
    Richard
    Participant

    Does anyone get SFJ magazine? Trying to track down a number of someone that makes bearings for these mowers. Thanks

    in reply to: Mccormick #7 mower #50304
    Richard
    Participant

    I went to the web site and went through the bearing section but didn’t find a match. I’ll call them to check. I’ve called everyone local with no luck. May have to go with bronze bushings as a replacement. Thanks

    in reply to: Grain Harvesting #49252
    Richard
    Participant

    Was talking to an Amish guy about pulling a grain drill not long ago. He has a 12 footer too. Said 2 of his horses can pull it but prefers to use four. The reason being they can can drill longer between rest breaks. This guy has 15-1800? pound Begians. Hope this helps.

    in reply to: Mower Photo request #49552
    Richard
    Participant

    I was checking out the old mower and found 1/2 inch bearings inside the counter shaft nut. If you already know about these disregard this message. I’m stumped.

    in reply to: Mower Photo request #49551
    Richard
    Participant

    The manual for the number 6 shows roller bearings used for the wheels. Bearings somewhere else must have been someones attempt to improve it.

    Will a number 6 bar bolt up to a number 7?

    in reply to: NH House Bill 427 #49463
    Richard
    Participant

    Nice job. Very well said.

    in reply to: Change in Goverment? #49297
    Richard
    Participant

    Thank you Robert. You hit the nail square on the head.

Viewing 15 posts - 1 through 15 (of 17 total)