594 John Deere hay rake

DAPNET Forums Archive Forums Market Place Buy/Sell Equipment 594 John Deere hay rake

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #40614
    firebrick43
    Participant

    I found a good deal on a roll a bar hay rake so this rake has to go. I really don’t want to cut it up for scrap so make me an offer. It has good teeth, many 1 year old, good gear box excellent wheels, works good. Bad, the rear wheel hub retainers are no the best. Also the left side center basket support would be best if it was bushed.

    If you need parts let me know

    #52811
    Anonymous
    Inactive

    I assume you may have sold this by now. I am trying to find some parts to a 594 hay rake which i have. Namely, the assembly that turns the tynes. This has a cast iron housing and gears and connects on to the end of the rake unit. If I can not find the entire assembly I am looking for one of the idler gears that fit in this unit. This is about 7″ in diameter and has 26 teeth. It is exposed from the back side. Any help you can provide is appreciated, thanks peterellis

    #52809
    john plowden
    Participant

    I may have what you need – can you post a pic?
    John

    #52812
    Anonymous
    Inactive

    John:

    I finally got a photo of the assembly. See attached photo to this thread. If this does not open, I can email this to you by return email. My address is:

    [IMG]

    Thanks,

    Peter

    #52810
    john plowden
    Participant

    Peter – I have it
    John

    #52813
    TropicalHarvest
    Participant

    Hello Members,

    I am a farmer in Kenya trying to bring a relatively good JD 594 back to useful life. I am missing the Rachet Plates (removable gears that are in each of the wheels) that are used to couple the wheels to the driving mechanism (the shaft) that drives the gearbox. Do you have these?

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.