6' IHC cutter bar

DAPNET Forums Archive › Forums › Market Place › Buy/Sell Equipment › 6' IHC cutter bar

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 8, 2016 at 7:50 am #87986
    Mark Cowdrey
    Participant

    I am contemplating going to a 6′ bar. Anyone have one? Need bar only though would consider one with guards, shoes, etc.
    Thanks,
    Mark

    March 8, 2016 at 8:21 am #87987
    Donn Hewes
    Keymaster

    Hi Mark, I have one here, I might be making a trip up to Jay Fisher’s in early April. $100. D

    March 8, 2016 at 11:34 pm #88000
    Mark Cowdrey
    Participant

    Thanks Donn. I am interested. I’ll be in touch. I am planning to (probably) re-build an A-22. If I do I will want haybine guards w one topless guard, inner & outer ledgers, possibly backer plates, & adjustable hold-downs. Do you know if the pitman length matches a 7 or 9 or if it is yet another length?
    Thanks,
    Mark

    March 9, 2016 at 7:11 am #88002
    Donn Hewes
    Keymaster

    Hi Mark, Not familiar with the A – 22. What make of mower was that? I have all the other parts you want also. Looks like I will be heading up by Jay fisher’s for a quick look at the Cornish fair ground on April 1. I will keep you posted. I don’t think it would be that hard to make a new pitman and figure the length. I would just make sure to set up the mower as best I could before measuring. Planning for lead, and getting the pitman square to the flywheel. determining exactly how far in front of the wheel the shoe is; etc. Then I think you can pretty safely make a new pitman.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.