#9 Oil seals (again)

DAPNET Forums Archive › Forums › Equipment Category › Equipment › #9 Oil seals (again)

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 29, 2012 at 4:05 pm #43914
    near horse
    Participant

    I pulled my old crankshaft oil seal (pitman end) and went to replace it with what I received from MackNair’s but it looks like the seal(s) from Mack are much thinner than the old one. Am I supposed to use 2 or will one do the job? The old one looks to be a pretty substantial piece.

    June 29, 2012 at 7:26 pm #74385
    Does’ Leap
    Participant

    Geoff:

    I have only done this job twice (on 2 different mowers) and I used 2 seals both times. So far so good.

    George

    July 1, 2012 at 12:58 am #74386
    Jay
    Participant

    @Does’ Leap 35698 wrote:

    Geoff:

    I have only done this job twice (on 2 different mowers) and I used 2 seals both times. So far so good.

    George

    Ditto for me. Jay

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.