Clutch Lever Oil Seal Part #?

[Does’ Leap]

Anyone have the part number/manufacturer for the clutch lever oil seal on a MD #9 mower?

Thanks.

George

[Donn Hewes]

Hi George, All my book says is “oil seal for 5/8″ shaft – 20359 D.” I would try to get one from some of the regular parts suppliers. Bw Macknair, Joes Master equipment, Peachy’s. I am sure one of them would help you. Alternately about all you can do is try to measure with a micrometer and find some thing at the store. almost impossible. Trying to place an order tonight for mower parts. Kind of depressing as the parts I want cost slightly more than what is in the mower shop account. But the fun is priceless! Talk to you soon, Donn

Funny story, I was heading down the driveway the other day to do a little clipping across the street. A pin and key feel out of a # 9 wheel that had been on about 5 or 6 years! The wheel fell off and rolled down the bank. Fortunately I have a mower shop so it only took me an hour to put it back together and try again.

[Does’ Leap]

Hey Donn:

Thanks for the reply. I helping a friend rebuild a mower and he needs to replace these seals. He tried calling Norm at McNair’s, but apparently he is on vacation for a few weeks? I found Joe’s Master equipment # by searching DAP but couldn’t find Peachy’s. Do you have that number?

George

[Donn Hewes]

Hi George, I don’t have that number right off hand, but I have been planning to buy some pitman seals from them (better thicker seals) so I will have to find out the number. When I do I will post it. Donn

[mitchmaine]

pitman seals? i have two sitting on the dining room table. 476838 national. 1 1/8 x 1 7/8 i think.

[Does’ Leap]

These are seals for the clutch lever, smaller than the pitman seals. I got in touch with Brubaker’s and ordered some today.

George

[Author]

Posts