DAPNET Forums Archive › Forums › Equipment Category › Equipment › Pioneer walk behind plow
- This topic has 5 replies, 4 voices, and was last updated 14 years, 1 month ago by Smalltown.
- AuthorPosts
- September 30, 2010 at 5:40 pm #40317SmalltownParticipant
Does anyone have any experiance with this plow? What did you like/not like about it. I want to get a sulky at some point but would like to learn to use a walkbehind first and am considering the Pioneer if I buy a new one.
Also, using two Draft Horses what size bottom would be ideal, 12”, 14”, 16”?
Thanks,
September 30, 2010 at 8:25 pm #50831mitchmaineParticipanthi. i have a pioneer walking plow and used it the last two days. i bought it in an auction at mt. hope in ohio. i think i’ve had it four or five years.
the only problem i have with it is its weight. its a handfull. underway, its a dream. it can be touchy when you try to correct it because of the weight. never tried it with three, but think the 12″ is plenty of plow for two horses.
the advantages is/are working with pioneer. lots of parts and great service and friendly folk. ’bout all i can think to say on the subject.good luck with your search, if you ever find a walking plow made by wiard in new york, grab it. i have a small one of those and think its the best plow i’ve ever used.
mitch
October 1, 2010 at 12:18 am #50833SmalltownParticipantThanks Mitch that’s just what I was looking for. I was wondering about the weight, 257# would be a bit to manhandle at the end of furrows.
Jordan
October 1, 2010 at 1:46 am #50830JayParticipantI echo Mitch’s comments. Goes well in the ground. Jay
October 2, 2010 at 1:44 am #50832SmalltownParticipantThanks Jay.
October 4, 2010 at 9:27 am #50829greyParticipantYou definitely want to have the horses pivot it into position and just stand it up your own self, rather than wrestle it around. I don’t own a Pioneer but I’ve plowed with one a few times, as well as helped load it into the back of a pickup… it’s a beast. Plowed well, but a beast.
- AuthorPosts
- You must be logged in to reply to this topic.