Brake Master Cylinder

DAPNET Forums Archive › Forums › Equipment Category › Equipment Fabrication › Brake Master Cylinder

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • March 11, 2017 at 5:35 pm #90154
    JaredWoodcock
    Participant

    I am starting to build my forestry wagon and I need to figure out a brake pedal/master cylinder setup. I am going to be hitching it to purpose built forecart so that in the future I can unhitch it from the cart and tow it with a tractor or truck. Ideally the pedal and master cylinder will be a single unit so that I can have it on flex line for those times I disconnect it from the forecart.

    Any thoughts or places to source something like that?

    March 11, 2017 at 10:51 pm #90155
    Roscoe
    Participant

    How about setting up the Trailer with electric brakes and the forecart with a electric brake controller. So the brake would work when you pull with a truck and you could use the forecart for pulling other trailer which already have electric brake (stocktrailer).

    March 11, 2017 at 11:13 pm #90156
    JaredWoodcock
    Participant

    I am going to do an electric over hydraulic controller when I start pulling with the truck. I wanted hydraulic discs on the trailer because the electric brakes are not very dependable at the slow speeds in the woods and they are hard to lock out for loading logs.

    I just found a hydraulic clutch cylinder and I am going to build a bracket to mount a pedal, that way I can run it inline with the electric over controller similar to the hydraulic handbrakes that are put on rally racing cars.

    March 12, 2017 at 11:22 am #90157
    JaredWoodcock
    Participant

    Here are the first two parts, I will have to make a bracket and pedal, as well as a temporary fluid reservoir. I like the clutch cylinder because when I have enough money to buy the Electric over controller I can run the clutch cylinder inline so that both the truck brakes and foot pedal will work.

    Attachments:
    You must be logged in to view attached files.
    March 12, 2017 at 11:24 am #90160
    JaredWoodcock
    Participant

    Here is the electric over controller.

    http://www.etrailer.com/Trailer-Brakes/Hydrastar/HBA-10.html?feed=npn&gclid=CJO8_eOg0dICFcdXDQodoIAHLw

    March 12, 2017 at 11:48 am #90162
    Roscoe
    Participant

    Cool. I haven’t seen that before. It’s pricey, but well worth if you use it on a regular / commercial base.

    March 13, 2017 at 5:33 pm #90166
    carl ny
    Participant

    I have that same Lock Out for a parking brake on my VW dune buggy… works good.

    carl nny

    July 27, 2017 at 12:10 am #90551
    Draftee
    Participant

    Both those truck parts would work. Were you able to make the bracket and pedal?

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.